Home › Contents › How to Make a Kite

How to Make a Kite

For the upright get a good straight lath, as A B, in the annexed figure, and next procure half of a thin hoop or cane for the bow C D, and then tie the hoop to the upright at A, and take care to have as much on one side of the upright as on the other; otherwise your kite will be sure to fall on one side when flying. Notch the two ends of the dow C D, and tie a long piece of string to D; pass it round the upright at E, and then fasten it at C; next carry the string to A, pass it down to D, and tie it there: from thence it is to be continued to B, passed round a notch there, and carried up again to C, then down the upright at F, and up to D, where it is to be finally fastened off. The skeleton being thus finished, the next thing to be done is to paste several sheets of paper so as to form a surface large enough to cover the kite and allow of a little turn over to fasten the outer edges; after you have pasted the paper on to the skeleton, you must make two holes, in the upright, as at G, G, through which the belly-band is to be passed, knotting the two ends of the string to keep it from slipping through the holes. The wings are to be made of several sheets of paper, cut into slips, rolled close up, so as to bear some resemblance to a tassel, and tied to the sides of the kite at C, D. The tail, which should be about fifteen times the length of the kite, is made by folding a number of pieces of paper so as to be about an inch in breadth, and four inches in length, and afterwards tying them on a string at intervals of three inches, and is finished by affixing to the end of the string a large tassel made in the same manner as the wings. Tie the string with which you intend to fly the kite to the belly-band, and your kite is complete and ready for service.